Operating principle:

In the cutter-compactor, the incoming material is cut up and heated to just below the agglomeration point by frictional heat. Residual moisture evaporates and is extracted with a vacuum. This allows material with high residual moisture to be processed without pre-drying. Special guide features compact the material and direct it into the extruder screw. An electrically driven slider ensures optimal filling of the screw.

- Insulated container for optimal drying, low noise and higher energy efficiency
- Additional safety thanks to foreign body detection and water injection
- The cutter-compactor design is adapted precisely to the material requirements e.g. different container sizes, , choice of tools, and raw materials)